This surge supressor is designed to meet the requirements of indoor use for protecting 10BASE-T and 100BASE-T Ethernet - all 8 wires are protected. It uses state-of-the-art, avalanche diode and thyristor technology with low shunt-capacitance to reduce signal loss. This protector also has shielded RJ45 sockets. The shields are tied into the surge protection circuitry so that a surge on the shield will also be clamped.
The unit has an integral 10 inch long coil of 14AWG ground wired with green jacket and spade fork terminal used for connecting the protector to a good earth ground.
Typical application is to protect against lightning induced surges, AC power interference, electrostatic discharge, and ground loop energies for devices such as NICs, switches, hubs, repeaters, bridges, routers, terminal servers, media converters, etc.
Connectors — (2) RJ45 F, (1) 15 cm spade fork terminal
Wires protected — 8 (all)
Signals supported — Ethernet 10BASE-T, 100BASE-TX
Max. Data Rate — 100Mbps
Clamping Voltage — 12V
Response Time — < 5ns
Physical and Environmental
Dimensions (H x W x D) — 23 x 38 x 91 mm
Enclosure — hard plastic
(1) Surge protector with coiled green ground wire
(1) Modular RJ45 male-male straight through cable 15cm
Black Box Explains
Modular CatalogueThe book no IT-Specialist can do without!
Mail a friend