The Pre-Polished Fiber Optic Connector can save technicans a ton of time in the field. These connectors are so easy to install, you can do it in a minute! There's no hand polishing. No epoxy!
Proven mechanical splice technology ensures precise fiber alignment. A factory pre-cleaved, factory-polished ferrule couples to the fiber being terminated with precise mechanical alignment. A proprietary index-matching gel ensures a low loss termination to 50-micron multimode optical fibers. There are no expensive tools, no messy epoxy needed.
A factory-installed wedge clip holds the clamping device open while the fiber is inserted. This clip also enables the use of a Visible Fault Identifier (VFI) to provide a "pass/fail" signal once physical contact is achieved. The connector are compatible with 250-µm, 900-µm optical fibers.
This connector are available in LC, ST and SC versions, for 50-micron, 62.5-micron multimode and single-mode fiber, as well as for OM3 laser-optimized multimode fiber and 10-Gigabit. Connectors for each fiber type are color coded to industry standard requirements to help with identification during and after installation.
Cladding Diameter — 125 µm
Core Diameter — 50 µm, 62.5 µm, or 9 µm (see order information)
Ferrule — Ceramic
Fiber Type —
PP-XX-50MM/PP-XX-625MM: Multimode
PP-XX-50MM-10G/PP-XX-625MM-10G: Multimode, Laser-optimized multimode OM3
PP-XX-SM: SIngle-Mode
Terminations Supported — 900 µm, 250 µm